TESTING OF MOBILE PHONE

Mobile Phone Repairing Testing Methods

Faults in each part, component or section of a mobile cell phone can be repaired fast by using following 2 methods at the time of repairing mobile cell phone. These methods can also be used to find out faulty or damaged parts or components inside a mobile cell phone.

1. Cold Testing Method: When we check the value of resistance using a multimeter at the time of repairing a fault in any mobile phone, it is called cold testing. There is no need to give any power supply to the faulty mobile phone from any equipment such as DC Power Supply or battery during cold testing. Diode Range and Beep Sound from the multimeter is used to find fault in a mobile cell phone using the cold testing method of mobile phone repairing. In this testing method, the RED Probe of the multimeter is connected to the ground of the mobile phone PCB and the BLACK Probe is touched at the testing points of the mobile phone. During the fault finding and repairing process of each part, component or section, following correct values will be received:
   1. Ear Phone Connector Tip (+ , -): .500 to .700
   2. Loud Speaker / Ringer Connector Tip (+,-): .300 to .600
   3. Battery Connector Tip (+): .400 to .500
   4. Battery Connector Tip (Sense): above .800
   5. Display Connector Supply Pins: .250 to .400
   6. Display Connector Signal Pins: .500 to .800
   7. Camera Connector Supply Pins: .250 to .400
   8. Camera Connector Signal Pins: .600 to .900
   9. Key Tip (Row and Column): .400 to .800
   10. Charger Connector Tip: .600 to .700
   11. Vibrator Motor Connector: .40 to .500
   12. Power ON / OFF Switch Point (+): .600 to .900
   13. MIC Connector Tip (Analog MIC) (+,-): .700 to .900
   14. Battery Charging Out Point (+,-): .300 to .400
   15. SIM Card Connector Pin 1 (VSim): .500 to .700
   16. SIM Card Connector Pin 2,3,6: .400 to .800
   17. SIM Card Connector Pin 4 (GND): .00 (Beep)
   18. Micro SD Card Connector Pin 4: .500 to .600
   19. Micro Card Connector Pin 6 (GND): .00 (Beep)
   20. Micro Card Connector Pin 1,2,3,5,7,8: .600 to .800
   21. RTC: .400 to .500
   22. Data RX and TX Pins: .600 to .700